- Published on
Simply defined, cavitation is the formation of bubbles or cavities in liquid, developed in areas of relatively low pressure around an impeller. The imploding or collapsing of these bubbles trigger intense shockwaves inside the pump, causing significant damage to the impeller and/or the pump housing. Talk to technical team at water pump dubai for the service and maintenance of the pump.
If left untreated, pump cavitation can cause:
If left untreated, pump cavitation can cause:
- Failure of pump housing
- Destruction of impeller
- Excessive vibration - leading to premature seal and bearing failure
- Higher than necessary power consumption
- Decreased flow and/or pressure
Suction Cavitation
When a pump is under low pressure or high vacuum conditions, suction cavitation occurs. If the pump is "starved" or is not receiving enough flow, bubbles or cavities will form at the eye of the impeller. As the bubbles carry over to the discharge side of the pump, the fluid conditions change, compressing the bubble into liquid and causing it to implode against the face of the impeller.
An impeller that has fallen victim to suction cavitation will have large chunks or very small bits of material missing, causing it to look like a sponge. Damage to the impeller appears around the eye of the impeller when suction cavitation is present.
Possible causes of suction cavitation:
An impeller that has fallen victim to suction cavitation will have large chunks or very small bits of material missing, causing it to look like a sponge. Damage to the impeller appears around the eye of the impeller when suction cavitation is present.
Possible causes of suction cavitation:
- Clogged filters or strainers
- Blockage in the pipe
- Pump is running too far right on the pump curve
- Poor piping design
- Poor suction conditions (NPSH requirements)
Discharge Cavitation
When a pump's discharge pressure is extremely high or runs at less than 10% of its best efficiency point (BEP), discharge cavitation occurs. The high discharge pressure makes it difficult for the fluid to flow out of the pump, so it circulates inside the pump. Liquid flows between the impeller and the housing at very high velocity, causing a vacuum at the housing wall and the formation of bubbles.
As with suction cavitation, the implosion of those bubbles triggers intense shockwaves, causing premature wear of the impeller tips and pump housing. In extreme cases, discharge cavitation can cause the impeller shaft to break.
Possible causes of discharge cavitation:
As with suction cavitation, the implosion of those bubbles triggers intense shockwaves, causing premature wear of the impeller tips and pump housing. In extreme cases, discharge cavitation can cause the impeller shaft to break.
Possible causes of discharge cavitation:
- Blockage in the pipe on discharge side
- Clogged filters or strainers
- Running too far left on the pump curve
- Poor piping design
0 Comments
